PROCESS ENGINEERING

  • Plant optimization studies

  • Heat & Mass balance using HYSYS / UniSim

  • Single/Two phase pressure drop calculation in pipe

  • Pump hydraulic analysis

  • Pressure drop calculation in network

  • Two /Three phase separator (Horizontal / Vertical) sizing calculations

  • Flare K.O. Drum (Horizontal / Vertical) sizing calculations

  • Thermal rating of shell & tube heat exchanger using EDR

  • Process Calculation for Instruments

  • Control Valve Sizing

  • Process calculation for Safety Systems

  • Estimation of PSV loads for various contingencies

  • PSV / RD sizing

  • PVRV calculations for atmospheric storage

  • Blowdown study

  • Process design of tank heating coils

  • Heat gain-loss calculation

  • Determination of hydrate formation & estimation of methanol injection rate

  • Process calculations / Simulations studies

  • Development of P&ID’s from PFD’s

  • Process Simulation/Calculations training sessions for process engineers

  • Plant trouble-shooting activities

INSTRUMENTATION ENGINEERING

  • Instrument MTO

  • Instrument Index, I/O list,

  • Instrument Loop Diagram

  • Lighting, Earthing layout and GA

  • Instrument Hook Up Drawings & Mounting Details

  • Instrument Cable and JB Schedule

  • Overall block diagram

  • SIL study close out report

  • Fire and Gas engineering deliverables

LOSS PREVENTION

  • Fire fighting system layout

  • Layouts of fire and safety equipment and escape route layout

  • HAZID, HAZOP close out report

  • Project safety reviews

  • Design of water spray, Fire water Hydrant ring main and sprinkler & foam system

  • Loss prevention philosophy

  • Fire protection philosophy

  • Hazardous area classification drawing

  • HSE risk register

  • QRA study

MECHANICAL ENGINEERING

  • Equipment Data Sheet

  • Equipment General Arrangement Drawing

  • Equipment Fabrication Drawing

  • Finite Element Analysis Of Equipment

  • Vendor Document Review

  • Equipment Specifications

  • Mechanical Design Calculation

  • Nozzle Orientation & Support Clips

  • Internal Drawings

CIVIL ENGINEERING

  • Preparation of Structural and Foundations details for pipe supports

  • Preparation of Structural and Foundations details for equipment, platforms, pipe racks, pipe bridges etc

  • Preparation of Roads & drainage drawings and calculations.

  • Preparation of RCC detaxils for foundations, roof slabs, trenches etc

  • Softwares like STAAD Pro, Foundation 3D used.

ELECTRICAL ENGINEERING

  • Single Line Diagram

  • Electrical & Instrument Cable Routing Layout, Cable Sizing and Schedule

  • Electrical MTO, Specifications, Data sheet

  • Electrical Power requirement calculations

  • HV and LV Switchboard design

  • ETAP Analysis

  • Earthing, Lighting & Lightning System calculations

PIPING ENGINEERING

  • Plot Plan, Piping layouts, Equipment layouts and Piping Material Specification.

  • Isometrics, Alignment sheets and As-Built Drawings.

  • Pipe supports

  • MTO

  • Technical Evaluation of various vendor packages and piping items.

  • Expertise in non-metallic piping systems.

  • Stress Analysis of various piping systems.

  • Pipe modeling in 3D.

  • Software available:

  • CAESAR II

  • CADWorx